plotclaw2.m.html
Source file:   plotclaw2.m
Directory:   /home/rjl/git/rjleveque/clawpack-4.x/matlab
Converted:   Sun May 15 2011 at 19:15:58   using clawcode2html
This documentation file will not reflect any later changes in the source file.

 
%
% PLOTCLAW2 is the main driver routine for plotting 2d graphs for Clawpack.
%
%    PLOTCLAW2 is the main routine that the user calls to step through a
%    series of frames (i.e. fort.tXXXX and fort.qXXXX files).
%
%    Various parameters can be set in SETPLOT2.  The default version in
%    claw/matlab/setplot2.m can be copied to your directory and modifed to
%    set things up differently, or type 'k' at the prompt to get keyboard
%    control and change a value.
%
%    See also SETPLOT, PLOTFRAME2.


%
% plotclaw2.m
%
% generic plotting routine for clawpack and amrclaw output in matlab
% R. J. LeVeque, 1999
%
% Various parameters are set in setplot2.m
% The default version in claw/matlab/setplot2.m can be copied to your
% directory and modified to set things up differently, or type 'k'
% at the prompt to get keyboard control and change a value.
%
%---------------------------------------------------------------------

clawdim = 2;

disp(' ')
disp('plotclaw2  plots 2d results from clawpack or amrclaw')

% set plotting parameters:
whichfile = which('setplot2');
if strcmp(whichfile,'')
  disp('*** No setplot2 file found')
else
  inp = input(['Execute setplot2 (default = no)? '],'s');
  inpd = findstr('y',lower(inp));
  if (inpd == 1)
    setplot2;
    disp(['Executing m-script ' whichfile])
    disp(' ')
  end
end
disp(' ')

% the file setprob.m can be used to set up any necessary physical parameters
% or desired values of plotting parameters for this particular problem.

whichfile = which('setprob');
if strcmp(whichfile,'')
  %disp('*** No setprob file found')
else
  disp(['Executing m-script ' whichfile])
  disp(' ')
  setprob
end

%=============================================
% MAIN LOOP ON FRAMES:
%=============================================

Frame = -1;  % initialize frame counter

if ~exist('MaxFrames')
   disp('MaxFrames parameter not set... you may need to execute setplot2')
   break
   end

set_value('outputdir','OutputDir','./');
set_value('outputflag','OutputFlag','ascii');

amrdata = [];
while Frame <= MaxFrames

  % pause for input from user to determine if we go to next frame,
  % look at data, or skip around.  This may reset Frame counter.

  Frame_old = Frame;
  queryframe;  % this sets Frame

  if (Frame ~= Frame_old | isempty(amrdata))
    [amrdata,t] = readamrdata(clawdim,Frame,outputdir,outputflag);
  end;

  plotframe2;

end % main loop on frames